Hi all, my DSC is unresponsive. It does not show up in INPA and in ISTA+, it shows up as red (ECU not responding). I tried to reanimate with ISTA/P but it didn't work.
I only have the part number from an old INPA screenshot but not the ZB number.
How would I go about flashing the DCS with just the part number?
This was taken from the Identification page of INPA
DSC part no. 7846816
VarI: 5457
DiaI: 05B3
CoI: 8
HwI: 00
SW-No FSV: 11.9.0
SW-No OSV: 0.0.0
SW-No MCV: 0.36.143
SW-No res: 0.0.0
My cars vin is E697973
Full vin: WBSKG92030E697973
Is it possible to flash the DSC with just this information? If so, how do I?
I have a battery support unit and a bimmergeeks kdcan cable so thatbpart should be fine.
If it doesn't show up in diag, then it's not a flashing issue.
It's not powering up, or not communicating.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
Bookmarks