Looking for some guidance/suggestions…. I always have a very difficult time putting my tonneau cover on my Z3M…. I’m able to get the two outer buttons fastens (the ones near the doors) however I can never get the inner two buttons fastened…. Even when I attempt to snap in the inner fasteners first…. I know there are instructions however they don’t seem to work for me….. Does anyone have any suggestions or ideally a video?... Because I must be doing something wrong……. Thanks in advance
tonneau cover_1.jpgtonneau cover_2.jpg
Here's a thread that should help, with a youtube in post #17.
https://www.bimmerforums.com/forum/s...nstall-problem
Wayne
1998 M Roadster
1994 Honda ST1100--sold
2017 Yamaha FJR1300ES
I would just unscrew the tenax fasteners, take them out and spray a little silicone on them. Then snap them in and out a few times. Make sure they're not damaged also.
Z3'er, mine was the same issue. I unscrewed the male tenaxes from the backing. Then I could insert the cover with no issues. I've driven 80mph on the interstate and it doesn't move. I begin with one end; insert and fasten the tenax then insert around to the other side then insert the inner edge home. In cooler weather it stays in the house as it really stiffens kept in the trunk. My $.02.
Dave
A little old couple in a little old car
You're never going to get the boot cover fastened with the wind deflector with your hardware. You need the longer Tenax screws with the plastic spacers. Wind deflector on first, then the boot cover.
https://www.ebay.de/itm/233660431039...mis&media=COPY
Sent from my SM-G975F using Tapatalk
Last edited by s8ilver; 01-30-2023 at 08:12 PM.
Nathan in Denver
1999 M Roadster, VFE V3 S/C, Randy Forbes Reinforced, Hardtop, H&R/Bilstein, Apex PS-7, Supersprint
1999 Z3 2.8 Coupe, Headers, 3.46, Manual Swap, H&R/Koni, M Geometry/Brakes, M54B30 Manifold, Style 42
Bookmarks