I have a 1983 E24 633CSI and am looking for the connector between the Oxygen (O2) Sensor (one wire) and the wiring harness located in the passenger aft corner of the engine compartment. The connector disintegrated when I disconnected it. I am unable to even find a part number for it and it might be NLA. I can attach it without the connector but would like to do it correctly. It fits into approx. 15 mm hole in a bracket.
Thx, Dan
Last edited by fly170; 12-12-2022 at 04:47 PM.
Since I can't find an OEM replacement, I will use the part below which is available on Amazon. If anyone needs one, I had to buy 5.
Waterproof PG9 Cable Gland Plastic Cable Glands Joints Adjustable Connector Black for 4-8mm Dia Cable
Although you have solved your problem, Molex makes a wide variety of connectors. Digikey is a good source.
Sent from my SM-G955U using Tapatalk
Bookmarks