I'm planning on doing my valve stem seals this fall, and I'm going to pull the head off to do it, (never pulled a head off before) and since I have it off, I want to replace any parts recommended since this engine has well over 200K on it. I welcome any comments or suggestions about Items I should replace. (Question: are this parts still going to be available? if so where? Is Ireland Engineering still functional? I can't get my calls or e-mails returned)
Items I'm think about replacing:
head bolts
head gasket
valve springs
timing chain
timing chain tensioner
valve stem seals
timing cover gasket
valve cover gasket
Clean carbon off the top of pistons
have a machine shop check my head for flatness.
Last edited by typhoon320i; 08-18-2022 at 10:07 AM.
My Car Blog:
http://motoluvr.blogspot.com
My current cars:
'16 Fiat 500e (electric)
'92 Honda accord
'05 Scion xB
'81 BMW 320i
'12 Toyota Prius
My $0.02:
No need to replace the following:
Head Bolts: These are not stretch bolts, so they can be re-used if in good condition. Just clean them up.
Valve Springs: Unless you are planning a cam swap and want to run higher rpm, the springs are probably fine.
The rest of your list is good practice.
Cylinder Heads International- rebuilds these heads-several here have done this me as well, turn around time is fast.
1271956105001-50110769.jpeg
https://www.shop.headsonly.com/BMW-3...-4CYL-SOHC.htm
Randy
$450 for a rebuilt head, ready to bolt on? Sounds like a good deal to me. Looks like they are out of Dallas. Im definitely interested.
My Car Blog:
http://motoluvr.blogspot.com
My current cars:
'16 Fiat 500e (electric)
'92 Honda accord
'05 Scion xB
'81 BMW 320i
'12 Toyota Prius
Yes, they prepay for shipping back the old cylinder head as well and provide a box for it.
Randy
I'm think about to do this soon.
Do you know.....I assume the head is decked, and they have done a valve job, tested the valve springs. new seals, valve guides...
Do you have any pictures of it before you installed it?
So you were happy with your end result?
My Car Blog:
http://motoluvr.blogspot.com
My current cars:
'16 Fiat 500e (electric)
'92 Honda accord
'05 Scion xB
'81 BMW 320i
'12 Toyota Prius
Yes they do what they list and deck the cylinder head and spray a heat coating on it as well-viton valve guide seals to boot, send them the upper timing chain cover as well as they deck this with cylinder head so they are even. They do a good job and cost less than local shops by far. The pictures are buried somewhere.
Randy
+1 on Randy’s recommendation CHI took care of a head rebuild for me and the turnaround was fast.
Bill
Sounds good.
My Car Blog:
http://motoluvr.blogspot.com
My current cars:
'16 Fiat 500e (electric)
'92 Honda accord
'05 Scion xB
'81 BMW 320i
'12 Toyota Prius
Bookmarks