Hey guys and gals(?),
This may be a stupid question.
Is it at all possible install cams in an M52b28 without pulling the engine or head? i.e. Just removing the valve cover, vanos, etc?
If so, can anyone point me to a good DIY? everything I've seen online only shows the DIY with engine or head on a bench.
Thanks in advance.
yes
I don't see why the tutorials don't apply when the engine is installed.
Yes, it's possible. It's a lot easier in terms of access but it can all be done with the motor still in the car.
Many of us have done it many times. I have used DIY that I have found in these forums. Pelican Parts may also have a DIY. Having done it many times, I certainly would not take the time to pull the motor since that would double or quadruple the time.
https://www.pelicanparts.com/BMW/tec...licanparts.com
Last edited by pbonsalb; 08-15-2022 at 02:29 PM.
Thanks guys.
I actually found this youtube tutorial which answered my question and thought I'd leave it here in case anyone else was questioning the same thing in the future:
https://www.youtube.com/watch?v=wRnqy-7dT28
Bookmarks