Central DME problem (EML)

[diegom6]

Hi,

I got a 1988 (euro) 750iL which recently lost throttle input (both throttles does actuate when cycle the IGN key). When we connect the GT1 (clone with the ADS cable) LH/RH DME are clear of faults, however central DME shows, as seen (Looks like hhe DME has been opend in the past at some point) a fault:

EML system fault

I can't run any special function, just read and clear into the EML but problem persist.

There's any component that perhaps I can check in this DME? Is a problem common?

Thanks

3.jpg2.jpg1.jpg

[shogun]

The control module shown by you is Engine control unit Bosch 0-285-006-004 1-137-328-019 1-725-390 BMW E32 750i, EML control unit (EMS 2.2) Electronic engine control, P/No. Bosch 1137328019 / 0285006004 / BMW 1725390
Software 28RT8385, Vehicle applicability: 1987-1994,BMW 7' (E32) 750i/iL 5.0 220 kW / 300 PS, Engine: M70 B50 / 5012A Automatic,VINs: #GB81#, #GB82#, #GC81#, #GC82#, Reference numbers:
0285006004, 0285-006-004, 0-285-006-004, 0 285 006 004, 1137328019, 1137-328-019, 1-137-328-019, 1 137 328 019,12711725364, 1271-1725364, 12-71-1-725-364, 12 71 1 725 364, 12711725387, 1271-1725387, 12-71-1-725-387, 12 71 1 725 387,12711725390, 1271-1725390, 12-71-1-725-390, 12 71 1 725 390, 12711725392, 1271-1725392, 12-71-1-725-392, 12 71 1 725 392 https://www.tav-autoverwertung.de/sh...0-BMW-E32-750i

I have read about defective EML modules, capacitors have been replaced https://www.bimmerforums.com/forum/s...EML+capacitors