Installed, has literally 2 miles on it. Doesn't suit our needs.
asking $300 plus shipping
Fits standard small bearing head.
Right hand dist gear (clockwise)
Measured valve lift 10.6mm (0.417") Intake and exhaust.
Not a regrind, this is a NEW Billet.
Last edited by autox320; 03-15-2022 at 06:31 AM.
88 M3
91 318is
91 318i
83 320is
08 X3 3.0si
"If it flys, floats, or f*cks, rent it!"
This cam is like a 304 Schrick but with more lift on the intake. 10.6mm/10.6mm vs 8.2mm/10.7mm
This 302 is only 6 degrees less overlap when compared to the 304. 82 degrees vs 88 degrees.
Would need a pre 80's distributor for clockwise gearing.
Still this is a large camshaft. Recommended install is 109 lobe center as on the spec sheet from IE.
This cam was a 2 month wait time when ordered @$340 plus shipping.
Reducing to $300 Shipped inside the US.
88 M3
91 318is
91 318i
83 320is
08 X3 3.0si
"If it flys, floats, or f*cks, rent it!"
I shared with the 02 folks in my area..
88 M3
91 318is
91 318i
83 320is
08 X3 3.0si
"If it flys, floats, or f*cks, rent it!"
Bookmarks