Note: Anything after 7/1990 , I can't use. Mine uses the earlier version. If it's correct, it only has two Belden cable mounts. The lower slider attaches to the circuit board.
I'll take just the switch assembly if that's all you have.
Looking for the module (dials, etc), but will take just the switch PCB assembly. It has to be pre-7/90.
You'll know it's the right one because it only accepts 2 Belden Cables. The lower slider is attached to the switch PCB.
Last edited by ross1; 01-18-2022 at 03:26 PM.
If you can leave two black stripes from the exit of one corner to the braking zone of the next, you have enough horsepower. - Mark Donohue
Bookmarks