I decided to replace the power steering pump along with the reservoir and low pressure line connecting the two. I would like to completely get out all of the current fluid left in the remaining lines, how should I go about this? Thanks for the help
There's a drain on the pump so once its all connected again run it turning the wheel then drain what you can from there then extract from the reservoir. I used a 'baster' to extract the fluid from the reservoir add more fresh fluid, repeat until you've replaced the volume..
https://www.bmwe34.net/E34main/Maint...g/PS_fluid.htm
Last edited by jehu; 12-09-2021 at 08:47 AM.
Just remove the two lines entirely so they can drip dry. Reconnect system, refill, bleed in the air with the engine running, and re-change the power steering fluid if you need to be extra clean (how messed up was this car???).
Bookmarks