Need help finding driveshaft or part number for a driveshaft
I have 95 e34 5 speed
Transmission seems to have come out of a e46 330ci has a the smaller tri prong
Your car should have a Getrag 250, unless it was swapped to a ZF320, and ZF320s have to larger flange. Easy to tell for sure, one says getrag on it and the other says ZF. Use https://www.realoem.com/bmw/enUS for part numbers.
Last edited by varg; 12-04-2021 at 12:40 PM.
'91 318is, M20B25, T3/T04E 60 trim (18psi), megasquirt, coilovers, Z3 rack, cold AC. Project thread
'94 525i touring slicktop, 3L stroker M50 w/BW S362SX-E
I have a 1995 525i
Transmission was replaced with a getrag 5speed out of a 330ci
Looking for a replacement driveshaft with a small tri prog and a 6 bolt v to diff
Been looking called a bunch of driveshaft places
Euro specialist
Bmw
And have had no luck on what I could use
Contact these folks: http://www.driveshaftspecialist.com/
Eh, maybe. These guys are highly recommended across many BMW forums, however I didn't have success with them. I had them make a custom driveshaft for my manual swapped e32 740iL and the first shaft they sent had the dimensions wrong (both front and rear sections were too short). The shaft wasn't the best quality either. Some sloppy fabrication and paint work, some welds had corrosion on them, the center bearing was an off-brand generic item, generic brand rear CV joint, etc... They sent a replacement shaft that had the correct dimensions but the rear CV joint assembly was different this time and didn't have the rear studs on it. The second shaft was also kinda questionable in quality. They agreed to a return and refund which was nice.
Also, at least in my case, they don't make the driveshaft themselves. They have PowerTrain Industries (Dorman) fabricate the shaft and send it out for them. I will say their customer service was fantastic; they were super helpful and responsive about everything. The price was pretty damn reasonable too.
Last edited by m60power; 02-09-2022 at 08:56 PM.
I had great luck with Beyer Driveline in Chandler, AZ. They melded two driveshafts into one for me and rebuilt everything with OE quality parts. Shipping wasn't terrible and I am sure they can make you a custom set up.
I’ve called them a few weeks ago they where so helpful sat on the phone for 3 hours with guy trying to figure out what driveshaft I have or that would fit and we had no luck
I want to get a part number or a car I could pull one out of that would work but no one knows
They were Great and helpful tried for 3 hours on the phone trying to figure out what driveshaft but was unsuccessful
Just want to know if there is any direct replacement. Or one I can pull from some other bmw that will fit
Bookmarks