engine CEL help
Hi guys, I was wondering if you could help out with a couple CEL codes Im getting? "Mixture deviation", cylinders 1-6, and "Oxygen-sensor control limit", cylinders 1-6.
I've read this is mostly intake related, I have a new HFM, and have smoke tested the vacuum system (fixed a few hoses), but not the intake manifold. These problems started a few weeks after my new engine install, I'm guessing hardware issue or sensor. When driving it hesitates, and is obvious something is not right. When I use my second tune it revs at idol and stalls out when not in gear. I know these are classic signs of extra air past the HFM, just run out of places to look. Was wondering if you guys may have some advice?
• Built S52 w/Dinan ISR-3 kit, NickG Stage 2+ Tune, Dinan Vortech V2 Supercharger, Dinan Air to Air Intercooler, Dinan CAI, Porsche 803 HFM, Buldogge 6" crank pulley, Griptec 2.90" blower pulley, Eurosport UD pulleys, Dinan 3.38 Diff, Dinan front/rear Swaybars, Dinan springs, Koni Yellow Sport Struts, Ground Control end links, South Bend Clutch Stage 3 Organic, AASCO Light Weight Flywheel 18.5#, Zionsville Radiator & Oil Cooler, Riot Racing BBTB, Schrick Intake Manifold, 42# Injectors, Schrick cams 264/256, Forged Wiseco pistons 9.0 comp., Forged Eagle rods, Supertech dual valve springs & valves, VAC crank & bearings, Supersprint mufflers, Euro Z3 midpipe, Raceland euro headers, Walbro 255, Bevauto ignition coils, Vortech Mondo bypass, Bailey Diverter DV30, Ireland Rear Subframe Bushings, Mason Engineering Strut Brace, Mason Engineering Clutch Petal, Apex 18" EC-7 Wheels, Full Custom Sound System, two trunk lids (with & without OE spoiler), Hardtop, Trunk full of AK's...
Bookmarks