Hello, n00b here, my 2017 F30 is throwing a bunch of codes that won't reset. I thought it was the battery so I replaced it, codes persist. Thanks for any help.
Here's the list:
DSC - 48082B Wheel speed sensor - front left - supply - short circuit to positive or open circuit
Engine - CD944D - Flexray message (actual speed wheel signal error)
- 1BD508 - Vehicle speed, wheel speed, front/left, electrical malfunction
- 1B0A21 - Rough road detection; no receive wheel speed
Integr. Chassis module
- D017A3 - Signal fault (actual number of encoder wheel flanks. DSC module invalid
- 482651 - Slip angle estimator - inputs not valid sbs
The codes clearly say that the front left wheel speed sensor has a problem. I would start there. Check its wiring and connector, and if all good, then replace the sensor.
- - - Updated - - -
When you replaced the battery, make sure you registered the replacement battery into the car.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
I just found some rat poop on top of the engine so I'm looking for chewed wires etc.
Wires all look okay, still looking for ideas. Thanks
Swap left to right sensors, just in case the replacement was bad. Inspect the ring that the sensor reads from as well.
And if no change, I would read sensor output with an oscilloscope to see if it's actually doing its job or not.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
What was the final outcome here?
- - - Updated - - -
What was the final outcome on this issue?
Bookmarks