My EML and check engine just came on

[estoque]

Sounds and feels like misfire...as soon as I committed to bite the bullet and get my AC fixed this happens to me

I think I read cleaning the maf and throttle bodies can fix this any ideas what’s going on?

[Laserface]

If the check engine light is on, there should be stored error codes. Do the stomp test and see what codes the car gives you.

[estoque]

If the check engine light is on, there should be stored error codes. Do the stomp test and see what codes the car gives you.

1222 oxygen sensor?

just started the car and the codes are gone and it runs normal now but there’s a new finding...the right side exhaust is a now smoking and smells

[rjjablo]

Pull all 4 relays in the EML Box and test them with a multimeter. One of mine was flaky and caused this $20 for a new one

[estoque]

Pull all 4 relays in the EML Box and test them with a multimeter. One of mine was flaky and caused this $20 for a new one

I’ll keep that in mind thanks. I’m gonna try cleaning the maf and throttle bodies first because a couple weeks ago my EML came on and the trans fail light came on and the car went into limp mode so I think that might be a fix...I let the car sit and those codes went away and the car drove fine for like 2 weeks before this

[rjjablo]

I’ll keep that in mind thanks. I’m gonna try cleaning the maf and throttle bodies first because a couple weeks ago my EML came on and the trans fail light came on and the car went into limp mode so I think that might be a fix...I let the car sit and those codes went away and the car drove fine for like 2 weeks before this

You are into one of the 15 Reasons it will go into Trans Fail Mode. None of which are typically the O2 Sensors The EML/fuel pump Relay would do it when I hit a bump

[dragon850]

99% it's your throttles.
PM me, I can re manufacture them for you.

Second culprit is your EML computer, but very little chances of that.

[estoque]

You are into one of the 15 Reasons it will go into Trans Fail Mode. None of which are typically the O2 Sensors The EML/fuel pump Relay would do it when I hit a bump

99% it's your throttles.
PM me, I can re manufacture them for you.

Second culprit is your EML computer, but very little chances of that.

cleaned out a bunch of grime out of the throttle bodies and sprayed down the mafs too codes are gone and it sounds like it’s back to normal...I think it’s time to change out the spark plugs too