Passenger restraint system 2011 BMW 528i xDrive

[lnthanh1906]

Hi everyone,
I have a problem with my car, the 2011 BMW 528i xDrive. The error pop up on my dashboard “Passenger Restraint System right after I jumped my friend battery. I did some research and I think my BST cable from the positive side of battery was damaged. The easy way to fix this problem is 2 ohm resistor on the BST. I just want to ask which one is BST cable?
These are photos of my battery
https://ibb.co/YbsQTXf
https://ibb.co/QnsWVCS
https://ibb.co/wYFY6P6
https://ibb.co/khnP6w4
https://ibb.co/nn050gc

Hope y’all doing good this weekend!

Thanks a lot

[White94RX]

Do NOT attempt any repair to the airbag system without first reading the fault codes. ANY repair on a vehicle without reading fault codes is absolutely dumb. You may think you know what's wrong, but unless you read out the fault codes, you are merely guessing. Don't just throw money at the car unless you are sure you know what is the problem. If you don't know what wires and cables are part of the BST system, then I would highly recommend seeking the advice of a professional.

And if you think adding a resistor to an airbag wiring harness that is part of the vehicle's safety system and could save your life, then you need to think again. Repair it properly. It's your life and the life of your passengers!