So Cal - Riverside area. Inland Empire.
I am looking to get about $900.00 for everything I do not need to keep for my track car and DD. You need to bring a Pick-up or trailer.
I have had e21's since 1989 and collected extra/modifying parts since 1995 or so when I started driving and auto-xing our 80iS. Some of the stuff is dirty
I have some of the dash out of the 79 euro 320/6
Engine short blocks all 1.8 1980 or newer
One apart and one assembled was a runner that had a cracked head I took off. Have the/extra 1.8 crank, rods and pistons.
0ne - Front M10 subframe
Front 1980 up iS sway bar
Two - Rear subframe
Pair of 1980 rear trailing arms - no brakes mounted
Rear Sway bar with some of the mounting hardware
89 E30 iS intake with injectors and Misc parts – was thinking of using it on the track car, decided not to.
Fuel distributors for 80 up 1.8, warm up valves, other fuel system parts.
Early 2.0 air flow sensor on 1.8 bottom with fuel distributor
Misc fuel system parts.
So / so tail lights for 79 older
Rear 1980 seat frames with bad original cloth covers
drive shaft (64") long 80 to 81 5 speed
intake for 1.8
MISC engine parts
Door class out of 79 track car
1970's Moon Roof - this is a tinted glass poop up/out roof (sun roof).
Trunk lid - has holes for once installed spoiler I no longer have.
1981 Rear bumper with shocks and side bellows
Oil Pan – some aluminum timing chain cover parts
323 open diff think it is 3:64 ratio
3:91 welded diff I used for auto-xing I replaced all the sealed when I had it apart t weld, it has Redline gear oil in it
lots of misc. other parts
I parted out one car for the parts and bought parts through the years.
Actually too much to list without spending 3 or 4 days going through it all. I have parts in boxes throughout my garage.
If you can send me an E-mail I can send pictures to I have some.
AGAIN ONE BUYER WITH TRUCK - VAN or Trailer
parts 5.jpg parts 11.jpg parts 1.jpg parts 13.jpg parts 8.jpg
Last edited by OLD MAN; 05-22-2020 at 02:22 PM.
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
Old Man, what area are you in?
I live in Corona - Riverside Ca area
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
Daryl : I want 1.8L block in picture 1,lol
Randy
Last edited by 320iAman; 05-22-2020 at 03:27 PM.
I can tell you where I live - but . . . LOL
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
If you do start to part out stuff individually I am interested in the 2.0 air flow sensor. But thats a lot to deal with so hope you find someone to take it all off your hands.
'81 E21 320i / '90 E30 325i / '̶9̶2̶ ̶E̶3̶4̶ ̶5̶2̶5̶i̶t (sold) / '15 Toyota XW30 / '̶̶8̶0̶ ̶E̶2̶1̶ ̶3̶2̶0̶i̶A̶ (sold)
Thank you - just the "thought" of dealing with each piece by itself is OVER WELMING!!
Maybe you and Randy and someone else up there could get together come pick it all up. Take what you want and sell the rest? Pretty sure it could bring $1,500 or more pieced out? What do rear subframes go for now? Glass?
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
Oh if I had the space I would take it off your hands. Not much fun hauling a 5-speed up my apartment stairs so I don't want to imagine a whole block or engine.
'81 E21 320i / '90 E30 325i / '̶9̶2̶ ̶E̶3̶4̶ ̶5̶2̶5̶i̶t (sold) / '15 Toyota XW30 / '̶̶8̶0̶ ̶E̶2̶1̶ ̶3̶2̶0̶i̶A̶ (sold)
I'm interested in the intake and at least the injectors for the e30.
Sent from my Pixel 3a using Tapatalk
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
I could use an e30 TB or suitable application for the intake as well. I have a 70mm TB and need to downscale a bit for NA
Sent from my Pixel 3a using Tapatalk
Daryl, if you decide to sell separate and ship I'd take iS swaybars (front/rear) and not broken plastic/rubber K-jet fuel lines you can find.
Always FUN TO DRIVE - Build Thread & Tech info - 79 320/6 track car build thread -- Videos of track car -Adam in car Auto-x video - Start-up video - 4/2011 Adam's TOP BMW time San Diego BMWCCA - 4-5-15 Dyno break-in run new M20B25 - Exhaust Thread - Link
Bookmarks