Prepping my spare head to swap in. Notices pitting around the water holes. The HG seals most of the hole. Feels too deep to have cut out. Options ?
IMG_5523.jpgIMG_5522.jpg
Sias Tuned, Vortech Blown, 3.2L S52...456WHP/360WTQ
Sias Tuning | HowertonEngineering | Davis Motorsports Club
You can have it milled they sell thicker head gaskets
Depending on your machine shop costs, it might be worth having it decked just to see.
Spoke with a machine shop. Those spots would need to be cleaned out and welded then shave the head.
Sias Tuned, Vortech Blown, 3.2L S52...456WHP/360WTQ
Sias Tuning | HowertonEngineering | Davis Motorsports Club
Buy a better condition head unless you have expensive port work on that one.
Let me know if you want an S52 head, I have a few in the garage.
"Be who you are and say what you feel because those who mind don't matter and those who matter don't mind."
-Dr. Seuss
DIY BMW Tools. Charlie For President
I don't think its worth it to put much labor into the head so ill just scrap it. I have a lead on a local head but if things fall through I will let you know. Shipping would be expensive.
Sias Tuned, Vortech Blown, 3.2L S52...456WHP/360WTQ
Sias Tuning | HowertonEngineering | Davis Motorsports Club
Bookmarks