I have passed the BMW scanner to the car and activated some functions, but after activating them it gives me the following error in red in the IKE module: BF [191] Internal fault EPROM checksum 1 (BMW-section), incorrect / incomplete coding
To try to remove the error, I have given recalculate eeprom checsum and it gives me the following message: No EEPROM checksum calculation for this IKE.
Could someone tell me what steps I would have to do to be able to remove the error?
thanks
There may be better ways to do this, but I would return coding to stock with NCSExpert and then attempt to make the changes with NCSExpert only.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
Bookmarks