I have (2) sets of VAC side mounts. These were purchased Dec 2019 and are the latest version with 4 holes on either end instead of 3 & 4. Used to mount Sparco QRT-R seats in my F80 but found them too low for both my wife and I to share the car. The QRT-R’s have the rear hole around 1-1/2” higher than every other seat out there by design so I ended up buying the Sparco specific mounts.
These sell for $119.95 plus shipping at VAC.
$120 shipped for (1) set or $220 shipped for (2) sets.
Only used to mount and test fit, never driven. Only the slightest handling marks. One mount (shown far left), which I put on the inside, has one nick from me that you can see being silver, and that same mount also has a nick from VAC that was painted over.
6622D321-DAEB-4747-A458-AF453E86376C by D S, on Flickr
858FD6D0-9A0D-46A4-9FDE-B816C9ACC55A by D S, on Flickr
D8B26B2F-46A3-40A4-8B9E-6F6F0FF2D1C5 by D S, on Flickr
E36 M3 journal https://www.bimmerforums.com/forum/s...-Build-Journal
F80 M3 journal https://f80.bimmerpost.com/forums/sh....php?t=1734421
Miata K24 build https://www.miataturbo.net/build-thr...ine-up-105885/
Bump
E36 M3 journal https://www.bimmerforums.com/forum/s...-Build-Journal
F80 M3 journal https://f80.bimmerpost.com/forums/sh....php?t=1734421
Miata K24 build https://www.miataturbo.net/build-thr...ine-up-105885/
Sold
E36 M3 journal https://www.bimmerforums.com/forum/s...-Build-Journal
F80 M3 journal https://f80.bimmerpost.com/forums/sh....php?t=1734421
Miata K24 build https://www.miataturbo.net/build-thr...ine-up-105885/
Bookmarks