Hello , I tried to update my ecu by winkfp ( I previously do that successfully ) after the loading appears 2% the gong sound heard , engine safe , Trans safe and coolant temp went to red , dsc on , the car no crank .
I tried to reach it in inpa , but i can’t.
Another trials of updates by winkfp it stopped in 2% and gives error
I put power supply charger before programming , any idea ??
Sent from my iPhone using Tapatalk
Where did you get the cable from? Is it setup properly?
At this point I would contact DUDMD on this Forum, he will know what to do - at this point you are on a dead-end road.
Timm..2007 E64 650i Individual Sport..1999 E31 840ci Individual Sport..ex owner of 2000 E38 740..1999 E38 740i V8 M62..1998 E38 735i V8..1993 E32 730i V8..1988 E28 518i
My BMW Repair YouTube Channel
My Current 840ci Sport Individual
My Current 650ci Sport Individual
My E31 Repair and Information Website
My E38 Repair and Information Website
My E63/E64 Repair and Information Website
Chase - Heroes to a generation
+1
01' 750il Chromeline
95 M3 LS swapped
07 M5 Manual
06' M5, Spartan wheels and a 507hp V10
00' 740il Dinan, CAI, Romulus exhaust, Stage 5 engine and transmission tune, 750 brakes, camber plates, strut tower brace. Sold
00' 323i wagon for daughter
03' 525i wagon for the wife, sold
98' 740i for the daughter, wrecked
92' 525i with over 200k, wrecked
02' R1200 CLC, hit by a bus and broken in half. That one made the news!
It's like herpes there is no cure but if treated properly you can live with it for the rest of your life
Make sure the latency timer for the USB cable is set to 1 and not the default of 16 in the device manager...
Last edited by haydar alameen; 02-16-2020 at 06:21 PM.
finally I change the version of winkfp and I have another cable ( even the previous one works ) the winkfp can reach the dme and update is done , the car is fine , thank you every one
Sent from my iPhone using Tapatalk
Bookmarks