Hi,
I have a 2006 X5 (e53) and I recently installed ISTA+ v4. I changed my transfer case oil, and will be replacing my transfer case servomotor.
I have read one needs to perform an adaptation via the "Service Functions" in ISTA+ after such work.
However, when I go to "Service Function" there is no transfer case or servomotor to be found.
I also tried to find the function with a Foxwell NT530, it was not present there either. I'm wondering if the info I've seen on the internet regarding the ATC 500 transfer case, and the need to do the reset/adaption, is not accurate.
Regards
Hi.
Did you get an answer to this?
I am looking at doing the same service.
Bookmarks