Hey you all I got a gear reduction starter today , it really !!! cranks the engine good the guy at the starter shop found it for me BOSCH / 410-24065. I was a little worried about it messing up the teeth on my fly wheel but we measured and looked real good at both starters and its got the same nose on it ,Works great
Here is my old writeup - https://www.bimmerforums.com/forum/s...-and-stud-swap
Photobucket sucks now.
I make E23 parts.
09/1983 745i (stolen spring '13 around Houston, TX Achatgruen on nutria buffalo. 8481080)
10/1984 745i
11/1984 745i
11/1984 735i (10:1-265/6)
Ford, MB, and GM round out the pack.
I am using an e38 V12 starter, the beefier of the gear reduction starters, on an M30 and it also was a direct swap.
Steve H.
yep thats the one I got pretty easy to put in !!!
Did you use studs in the block too? That makes life easier yet!
I make E23 parts.
09/1983 745i (stolen spring '13 around Houston, TX Achatgruen on nutria buffalo. 8481080)
10/1984 745i
11/1984 745i
11/1984 735i (10:1-265/6)
Ford, MB, and GM round out the pack.
Bookmarks