Hello everyone ! i wanted to share my project here on forum maybe this helps to someone in future project or maybe someone will advice me something i missed ) anyway thanks in advanced
So, my last BMW i sold back in 2006 and since i didnot even drive any of them the car i will post here i bought without engine so i dont drove it as well
since last bmw in 2006 i bought R33 skyline and have driven till present on skylines i had them all except R34 GTR but this is another story few month ago i bought good looking fresh R34 touring, i liked the condition for the age it has minimal rust and interior was also good seems like it was not driven for the years, as i mentioned i had skylines so for this time i got some skills swaping them to different models and tuning them, so for start i though will go with rb25 or 26 project with rb30 bottom end but at last moment i decide to go and try new fruit ford barra!
i start the project few days ago and its just in rush so mostly i will change lately or finish normally all the steps i have done, important for me was it possible to fit this huge block inside e34 coz this engine sizes is way bigger then i get used rb25 rb26 even 30 and more even 2JZ
I have seen some project when people swapped steering system from other models but for the moment i will try and keep the standard one i dont know its good idea or bad but waiting for suggestions
i had no lift for the moment but lately for finish welding i remove suspension and will do it properly
Last edited by guricha; 01-02-2020 at 04:21 PM.
Bookmarks