Results 1 to 4 of 4

Thread: fuel door rubber stopper replacement PN?

  1. #1
    Join Date
    Nov 2007
    Location
    Greater NYC Area
    Posts
    707
    My Cars
    '00 z3 2.5L & '98 740iL

    fuel door rubber stopper replacement PN?

    while cleaning my car after taking it out of storage, the fuel door rubber stopper fell out... it's somewhere in my driveway.

    i replaced it a very, very long time ago, but i cannot find the PN for the life of me. RealOEM seems to only list the fuel door now. I would have bought it from trademotion.com, and the order confirmations i have do not list part numbers.

    to be clear, i'm talking about the small rubber nipple that sits in a slot of the fuel fill door and prevents the door slamming into the metal stop when closed. it also keeps the door flush with the body. it's about 0.25" dia, pointed on one side, narrow in the center where it sits in the door, and blunt on the other, about 3/8-1/2" in length.

    anyone have a PN and source?

    thanks!

    EDIT:
    found the answer here after some more searching:

    https://www.bimmerforums.com/forum/s...-gas-door-stop

    would delete thread but don't see how - i can only edit..
    Last edited by pwhitt; 06-26-2019 at 05:37 PM.
    Cheers,
    Phil

  2. #2
    Join Date
    Feb 2019
    Location
    PA
    Posts
    366
    My Cars
    2001 BMW Z3
    Just got one several months ago from PelicanParts.

    BMW Fuel Door Buffer Stop - 51178153364 For Z3, M3, E36, 328is, 328i, 325is, 325i, 323is, 323i, 318ti, 318is, 318i


  3. #3
    Join Date
    May 2002
    Location
    SW Florida
    Posts
    12,682
    My Cars
    99-01 M Cpe & Rdts, X5M
    DON'T REPLACE IT WITH SAME!

    As an act of courtesy, every time a car arrives here missing that bumper__that gets knocked off when you wash the inside of the fuel filler door (you DO wash that area every time you wash your car, right?)__I put a rubber bumper that was intended to go between the rear fender and bumper. Mount it to the tab on the body (after cleaning with a paint-safe solvent).

    The ones on my cars have remained in place for well over a decade without getting lost, and they're the correct height so the door sits flush with the fender.

    Might as well see if you need to replace the ones on the bumper ends too...

    https://www.fcpeuro.com/products/bmw...SABEgLL4_D_BwE


  4. #4
    Join Date
    Nov 2007
    Location
    Greater NYC Area
    Posts
    707
    My Cars
    '00 z3 2.5L & '98 740iL
    Thank you Mr Forbes!

    I was looking for the part you mentioned in the thread I linked, but had no idea where to start. And you're right - I've knocked it out every time I detailed the car. It'd been sitting for so long I forgot, it surprised me when it popped out this time.

    I'll take your advice.
    Cheers,
    Phil

Similar Threads

  1. E30 Fuel door removal and replacement
    By JIM1inWisconsin in forum 1983 - 1991 (E30)
    Replies: 2
    Last Post: 10-29-2020, 07:57 AM
  2. Door Rubber Gasket Replacement
    By team321 in forum 1996 - 2003 (E39)
    Replies: 11
    Last Post: 07-29-2019, 07:25 PM
  3. Need rear right door rubber seal/guides - PN 51348176587
    By katit2 in forum E34 Classifieds (closing soon)
    Replies: 3
    Last Post: 05-24-2018, 12:51 PM
  4. Fuel Door Lock Actuator Replacement
    By Wrekless in forum 1996 - 2003 (E39)
    Replies: 1
    Last Post: 03-14-2012, 11:03 PM
  5. Fuel Door Actuator Replacement - Extra Component
    By cgkhor79 in forum 1999 - 2006 (E46)
    Replies: 2
    Last Post: 09-18-2007, 02:10 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •