NCS Expert "VIN is faulty"

[alexthebmwguy]

Hello I have been trying to code my 2002 E39 all day and have gotten INPA to show the two black dots showing that the cable and ignition are on. But when I close INPA and open NCS Expert and load a profile, I select start, then choose my car (E39) then module (EWS) and it does not load the rest and I get an error saying "VIN is faulty". I went to the ncs expert website and downloaded the most up-to-date daten files and have tried updating them without any difference.
IMG-5487.jpg
I am trying to code in my bi-xenon headlights and reinstate my mirror tilt on reverse function. I had the engine swapped from a E39 2.5L to a E46 3.0L and had the DME reprogrammed and that seemed to take away my mirror tilt function. Have tried reinstalling several times without any luck. Please help.

[new2019]

Connect pin 7and8 and it will fix the issue, assuming you are using a k+dcan cable

[Plege]

Did you fix your problem? Im having the same issue with 2000/09 bmw e38 using 20pin round connector under the hood.