I need help finding out where each of the plugs, prongs get plugged into.
I started this last year and had trouble getting starter out, well getting to the top bolt till ordered the right part, tool to get it out. By that time, it was time to put it away for the winter.
Well I work on computers for a living and can't find the pics I was taking during uninstall and now kicking myself for not labeling them as I went. Think pics would be fine.
I have searched endlessly on what gets plugged back into and don't wanna cross em or what not.
I don't need any of the vacuum hoses. RealOEM all has that. But nothing really on where each plug needs to be plugged into.
Does anyone have a picture, write-up anything to point me in the right direction?
I can't thank you enough!
My email is jamie_ewing@msn.com if you can help me or if you need a # I can supply that as well!
After all this work, I just wanna get my M3 back on the road again.
Again, any help would be greatly appreciated!!
Did you find this when searching for e36 engine wiring harness diagram:
https://www.bimmerforums.com/forum/s...wiring-harness
Ha Ha, I have the main picture and printed it but never found the diagram for placements of each plug.. OMG Thanks very much!!!
Hope this works, will update!!
All Wrapped up for the night!
I only let her run for about 5-10 min
I know I need to run it for a while to get computer used to the increased air volume;God.. can't wait to take her for a drive tomorrow!
Finally!!
Seems like forever the car was down!
488.jpg
Bookmarks