I was reinstalling the strut nut on the front passenger side on an EDC strut and the nut got stuck at the top threads just high enough so that I can't get the 10mm far enough down to grab the teeth. (Just FYI, the EDC have the plastic connector to adjust stiffness in the middle, so I can't stick a hex into the strut tower. That's why the 10mm socket is used.) Trying to be really careful here so that I don't strip it. I was following bill's guide (http://www.billswebspace.com/M3HRSpringInstallation) using a 21mm wrench on the nut and the 10mm socket on the strut. Any suggestions?
IMG_3022.jpg
IMG_3023.jpg
From Bill's install thread so you can see you it's done.
image019.jpg
impact gun.
2011 M3 Sedan
2006 GMC Sierra 2500HD LBZ
1999 323i GTS2
1995 M3 - S50B32/S6S420G/3.91
1990 325is
1989 M3 - S54B32/GS6-37BZ
Hers: 1996 Porsche 911 Turbo
Hers: 1989 325iX
Bookmarks