I just finished rebuilding my A/C Compressor on my m6

[master6]

Fellow Forum Members.


Well, my Compressor had a very slow leak, but it was hard to tell where because of a previous owners valve cover leak.
The compressor was covered in oil and dirt, probably from many years of that leaking gasket.
So I decided to get this done before Summer.
I spent a lot of hours trying to clean up the oil leak mess under the motor, from below.


After clean up and disassembly, I had some of the parts re-plated Yellow Zinc, the same ones that BMW did.
I also ordered some new Labels from Kos in the U.K.


I am going to offer these new labels to my Clients when I do their A/C Rebuild.
And I can also offer my clients, to do their yellow zinc plating, during their pump rebuild.


I put even more photos on my A/C Website, starting on page 63
See # 12
https://www.bimmerforums.com/forum/s...rrent-websites


I am going to install the Compressor back into the m6 starting tomorrow.


Best,

P4290004.JPG P5060004.JPG P4290006.JPG P5110001.JPG P5110002-001.JPG

[n2bimmer]

Looks great

[Nullified]

Thumbs up!