A year ago I sent a computer to driiven to have him load it with INPA, DIS, and other stuff. He did that sent the computer back, and the modified cable will not allow communication. I have tried to contact him -- phone mailbox is full, messages sent within this site have gone unanswered, and I have even posted trying to get him to respond. Nothing.

I opened up the plug end and a connection has been on the board has been modified. Pins 1 and 9 have had a connection soldered. I have an unaltered k+dcan cable (about 5-6 years old) that works on an older laptop with old versions of DIS and INPA. The new computer "sees" it, and allows me to complete the connection in the dialog box that pops up when the selections are made for ADS or OBD2, but the software can't talk to the DME. The modified cable times out, so will not work.

Any suggestions?