Not a mind blowing part but thought it worked out well. 3D printed a slip in ccv fitting with dual o ring to connect 5/8” hose. Strong enough to wrestle on the hose and clamp without issue. Cost was rather low as well. I can post the files if anyone would be interested.
Sent from my iPhone using Tapatalk
Think this has been made already but good work nonetheless
Sent from my iPhone using Tapatalk
I'm interested!
Also, what catch can is that?
Looks clean. I have a hose clamped on top of the factory valve cover neck. The bigger issue is the size of the internal port, which is much smaller than the exterior neck. A few have opened it up but there is not enough material so you have to do more serious modification. Chikinhed posted details years ago.
Correct the interior is smaller. I will probably reprint later after I drill out the ccv port to enlarge it. I’ve designed a bracket to hold the SAP near the power steering reservoir. So I was not so concerned with ID as there will eventually be an assisted vacuum on it.
Sent from my iPhone using Tapatalk
I welded a short piece of 7/8” aluminum rod to a -10AN fitting, then used the hole in the fitting as a guide to drill out the rod.
I then JB welded that sucker into the valve cover fitting. Saw some guy on revlimited do that.
Sent from my iPhone using Tapatalk
Last edited by SilburE36; 03-13-2019 at 05:36 PM.
Looks great. Would love the files. I'm trying to figure out a solution for this right now.
CURRENT: LimeRockParkEdition E92 M3 - BSM/Silverstone E70 X5M - AW/Dove E36 M3
PAST: Techno/Dove E36 M3 - Techno/Dove E36 M3 - LSB/Black E46 M3
Looks great
Sent from my SM-G960U using Tapatalk
Nice work, please send me the file. (im sending my email through PM)
What material did you use? Im going to let a friend print it for me
Regards
Bookmarks