Hello Guys
I've bought an 740i from 2000, one of the reasons i bought the car was the cool feature S-EDC. But unfortunately it doesnt work.
When I put the Car in Ignition, the Light lights up for a short time and after that i cant enable the function.
I checked the ECU in the glove box, did a reconnect. After that I cleared the errors on the edc module and recoded it. I couldnt believe it, but after those steps i could enable it and
I also noticed the comfortable suspension. Before it was always on Sport-Mode. So i could switch the modes.
The next day, i wanted to test it again , but it didnt work anymore. I also did a Steering Angle Reset, but no Luck.
Attached you see the errors, does someone has an idea ? EDC Module defective?
Thanks in Advance
IMG_20190216_195925.jpg
IMG_20190216_200002.jpg
IMG_20190216_200013.jpg
No personal experience but I would say your speed signal is off. Should be front left wss.
https://www.meeknet.co.uk/e38/EDC_III_Plus.pdf
2001 750iL DD74441
Stock
RIP: 2003 540iA Sport GS56111
H&R front springs, Ultimate Cup Holder, Euro Dash & Armrest, Grom, BavSound Stage1
Thanks for your input, but in my opinion the sensor is good, because i didnt have any DSC/ ASC Errors on my instrument cluster, even if i read out the DSC Module, there are no errors.
I think my Module is defective
OT question - What is your diagnostics setup? Reason for asking is that I cannot connect to EDC module with neither software, INPA, DIS, none of these would pick it up. All other modules can be read with no issues though.
Its important that you use Ediabas 6.43 or 6.47 (INPA 5.01) and you need an ADS Cable, you can buy it here:
https://doitauto.de/ads-obd-diagnose
You cant connect to EDC via KDCAN
Regards
Bookmarks