Hello guys
I have a problem with my BMW E39 M62TUB44. The engine runs very well except for one thing. You could drive the car for a 200 miles trip and nothing bad happens, drives smoothly as a normal car. However, you just put the gas pedal down to floor (WOT) and immediately (after 1-2 seconds) Engine safe mode program appears. There is no gas pedal reaction then. Engine gets rough idle, bumping from 500 to 1500. You can turn the engine off, start again and works normal again until next WOT. INPA shows only 1 error code - 130 Throttle Valve Position Control . I tried another throttle body, tried deleting adaptations and there is no results. I read that people had problems with thermostat heater plug, but mine is OK, also all 30amp fuses in ebox are ok. Could you point me what to check next?
Thank you and best regards
Last edited by Maleckis; 02-15-2019 at 04:24 PM.
Bookmarks