Hello everyone,
I am looking for someone to point me in the right direction on how to code a ABS module to my wife's e53. I took the original module off and sent it to a service I found in eBay but upon re-installation I am still getting a code for left rear inlet valve. I originally had a speed circuit input issue. Long story they told me to send it back to them and they would look at it again and tell me if covered by their warranty. Well in the mean time I scored a used module that had no lights on the dash from a wrecked e53 for $50 and could not pass it up. I have the "Easy BMW Tools" loaded on a laptop and I also have ISTA+ but am still trying to figure out all the capabilities and need help in how to register the ABS module to the vehicle. Thanks in advance to anyone who can help