Results 1 to 8 of 8

Thread: 2000 2.8 Z3 Coupe 6 Speed

  1. #1
    Join Date
    Dec 2003
    Location
    SJ, CA
    Posts
    2,350
    My Cars
    '00 Z3C, '70 XJ6

    2000 2.8 Z3 Coupe 6 Speed

    I'm putting my much beloved Z3 coupe up for sale to its next steward. Selling as I'm now in a manual 911 and can't have two sports cars. I'm a former BMW mechanic and present engineer, so this one has been mechanically looked after despite its high miles.

    Cosmos black/black
    M52TU dual vanos
    220k miles
    6-speed manual
    Berkeley, CA
    $10k


    The high level:
    The car was originally an automatic up until 197k miles, which means it had no subframe cracking issues from hard 1-2 shifts. It was swapped, properly coded, and everything works as new but with an additional gear as I used the box and clutch from the e46 M3. The driveshaft and shift components are all OEM and shortened to fit the 6 speed. The carrier for the transmission is an OEM euro M3 6 speed mount. All suspension bushings have been gone through, with the exception of RTABs as they looked totally fine. It's using M3 front control arms, bushings, and '95 M3 upper strut bearings (more caster) for an OEM+ ride and drive. Subframe bushings are ireland engineering greens, and the rear diff mount is OEM and was replaced at the same time as swapping in a 3.46:1 torsen LSD. All stock wherever possible and maintenance is very much up to date. It comes with three keys and a functioning lock/unlock fob. Everything works. It has high miles - the paint is that of a high mileage car.

    The extra goodies:
    The driver's seat was in bad shape and I'm a tall guy (6'3") so I designed and made my own seat brackets to allow me to fit a recaro SPG XL with a helmet! I never got around to taking it to any track days, just canyons for this guy, but I'll include a brand new set of track pads with. The steering column has been lowered a bit (very easy to reverse) which is commensurate with the lower seat. I'll also include the roof rack and one bike mount if you so desire it.

    Notes:
    All the little things have been done to really make this thing great. Hatch harness is all good/repaired, felted all the squeaks, added an LED third brake light that flashes under emergency braking, mason engineering clutch pedal, euro under dash panels, bluetooth kit for the OEM CD deck, even down to the BMW branded USB cigarette lighter plug.

    Up next:
    The dashboard still squeaks on really rough roads. The steering wheel needs recovering. The driver's door seal could use replacing


    I really want this to go to a good home to someone who will enjoy it, so I'm listing it here first.


    Photo album: https://www.bimmerforums.com/forum/a...p?albumid=5807


    My running list of things I've replaced or repaired:
    217.5k
    - [x] 215k oil change + oil pan gasket
    - [x] 120A Bosch alternator
    - [x] Bead sealant on spare tire
    214k
    - [x] Rear brake wear sensor
    - [x] Front and rear sway bar bushings and links, drilled rear sway to stop bushing walk
    - [x] Wiper blades
    - [x] Vanos seals
    - [x] Valve cover gaskets
    - [x] Motor mounts
    - [x] Bluetooth stereo adapter + new volume knob
    - [x] Pressure washed engine and under body
    212k
    - [x] Seat foam thigh support
    - [x] Lowered steering column ~1"
    210k
    - [x] Tires Michelin PS4S
    206k
    - [x] Diff mount
    - [x] 3.46:1 diff
    - [x] Strut brace
    - [x] Drivers side mirror glass
    202k
    - [x] Oil change Mobil 1 0w40
    - [x] Drivers door lock cylinder re-key to match
    - [x] Lube window tracks/replace sliders
    - [x] Replace door clips
    - [x] Subframe mounts IE urethane
    - [x] Trunk latch
    - [x] LDP pump
    - [x] M3 '96+ control arms and bushings
    - [x] Tie rods
    - [x] Bimmerworld camber shim kit
    - [x] Alignment (-1.25 deg camber, 6.4 deg caster)
    198.5k
    - [x] Secondary air hose
    - [x] Tires kumho v720
    198k
    - [x] Mason Engineering brake pedal
    - [x] Hatch wiring harness repair
    - [x] Spark plugs
    - [x] Air filter
    - [x] Ebrake boot
    197k
    - [x] Manual conversion, six speed
    - [x] Rear main seal
    - [x] Shorten shifter 89mm
    - [x] Custom driveshaft
    - [x] Bump stops front
    - [x] M3 '95 strut mounts
    - [x] Transmission input shaft seal
    - [x] Third brake light
    - [x] Fuel pump
    - [x] Front tweeters
    - [x] Euro glove box
    196k
    - [x] Aluminum radiator zionsville
    - [x] Drivers seat Recaro SPG XL
    - [x] Fuel filter and lines
    - [x] Cooling system overhaul, incl hard plastic lines
    - [x] Oil filter housing gasket
    - [x] Brake wear light, shorted rear sensor
    - [x] Side roundels 51141970248
    - [x] Front/rear roundels
    - [x] Drivers door airbag clip
    - [x] Front right turn signal
    - [x] Light switch cover
    - [x] Dash cowl
    - [x] Hatch hinge covers
    - [x] Outside door handles and gaskets
    - [x] Seat bushings
    - [x] Seat tilt mod
    - [x] Order 2 new keys from dealer
    - [x] Keyless fob
    - [x] Floor mats
    - [x] Antenna mast
    - [x] SRS light fix
    - [x] Trunk struts
    - [x] Rear wiper blade
    - [x] Wheel roundels
    - [x] Vent knob light (2x) 61138353797


    Sorry it's a little dirty, thanks for looking,

    Bryson
    Last edited by Bryson; 02-12-2019 at 02:24 PM. Reason: adding photos

  2. #2
    Join Date
    Feb 2006
    Location
    Tim @ BMW of Dallas
    Posts
    1,889
    My Cars
    98 Z3 2.8
    I want to buy this car, just because it's so well sorted at a great price point. GLWS!
    96 320i Touring
    98 Z3 2.8 Roadster
    01 PY M Coupe
    96 Z3 1.9 - DASC
    95 318ti Clubsport
    94 Miata M-Edition
    13 smart fortwo



  3. #3
    Join Date
    Oct 2008
    Location
    SFBay, CA
    Posts
    309
    My Cars
    02 LSB Z3M Coupe
    Great car, lots of care taken in the work.

  4. #4
    Join Date
    Dec 2003
    Location
    SJ, CA
    Posts
    2,350
    My Cars
    '00 Z3C, '70 XJ6
    Thanks guys!

  5. #5
    Join Date
    Mar 2003
    Location
    somers,ny
    Posts
    4,040
    Quote Originally Posted by Tim95M3 View Post
    I want to buy this car, just because it's so well sorted at a great price point. GLWS!
    same here...lol

  6. #6
    Join Date
    Mar 2003
    Location
    somers,ny
    Posts
    4,040
    Quote Originally Posted by Tim95M3 View Post
    I want to buy this car, just because it's so well sorted at a great price point. GLWS!
    same here...lol

  7. #7
    Join Date
    Dec 2010
    Location
    Clovis, Ca, USA
    Posts
    8
    My Cars
    E70 X5M X5d X5M R56MCS
    I’m interested. Please PM me your contact information at your convenience.
    I’d like to discuss a meeting time and place

  8. #8
    Join Date
    Dec 2003
    Location
    SJ, CA
    Posts
    2,350
    My Cars
    '00 Z3C, '70 XJ6
    Sold a couple months ago!

Similar Threads

  1. Final inspection on 2000 2.8l z3 Coupe today, what to look for?
    By vanne in forum 1996 - 2002 Z3 (E36/7, E36/8)
    Replies: 5
    Last Post: 08-30-2012, 05:32 PM
  2. Z3 E36/7 NTB..(need to buy) 2000 2.8 z3 coupe rear hubs
    By projekt EPiK in forum BMW Parts Wanted
    Replies: 0
    Last Post: 02-07-2012, 07:24 PM
  3. 2000 2.8 Z3 Coupe value?
    By SRC60 in forum 1996 - 2002 Z3 (E36/7, E36/8)
    Replies: 14
    Last Post: 05-17-2010, 08:36 AM
  4. Z3 E36/7 FS:2000 Z3 coupe 2.8
    By HellrotZ in forum 3 series & Z Series
    Replies: 2
    Last Post: 03-06-2010, 04:00 PM
  5. Z3 E36/7 WTB: Stock airbox for my 2000 Z3 coupe
    By Tackleberry in forum Z3,Z4,Z8 Classifieds
    Replies: 3
    Last Post: 03-11-2009, 08:47 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •