hello, Ive performed a manual swap on my 2003 325i, did all the required wiring additions to the dme and ews for the clutch switches.
Im fairly familiar with NCSexpert on some things Ive done with it so far, but Im having a issue getting the EWS coded to a manual.
I used the expert mode and Revtors expert profile
Ive managed to code the AKMB and the ALSZ for manual without any issues
When I try to code the AEWS for manual, in the job codes I dont have the FA_WRITE option in the list, Ive tried SG_Codierian to code it and get the same error, also in the job list is two ZCS jobs, but I havent tried that because I have a facelift car.
Ive tried to process the whole car and get the same faulty coding error when it gets to the AEWS.
Ive checked the coding of the ews in INPA after attempting and it still indicates the car is still a auto, and its keeping the car from starting.
Any help will be appreciated, theres something Im probably over looking or not selecting the right job, thanks
Sent from my SM-G892A using Tapatalk
I figured out my problem, my coding was correct, the key I have went bad, it quit communicating with the ews. Gonna take care of it within the week
Sent from my SM-G892A using Tapatalk
Don't forget to clear DME adaptations after coding, so it may take on manual mode.
-Abel
- E36 328is ~210-220whp: Lots of Mods.
- 2000 Z3: Many Mods.
- 2003 VW Jetta TDI Manual 47-50mpg
- 1999 S52 Estoril M Coupe
- 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
- 2019 M2 Competition, self-tuned, 504whp
- 2016 Mini Cooper S
Bookmarks