I have a 2003 bmw 325i, one day I started the car and I couldn’t put it in gear no matter what I did. I pulled the transmission twice already and replaced the clutch, pressure plate, throw out bearing, master clutch cylinder, slave cylinder, and fully bled it. The second time I pulled it, the fingers on the new pressure plate where are pushed in for some reason, so I thought maybe I just received and defective pressure plate and the old one didn’t even look bad so I thought maybe the problem wasn’t even the pressure plate to begin with. But now it’s still doing the same thing, won’t go into gear and pedal hard to push. Any feedback would be helpful, thanks.
Moved from the General BMW Discussion sub-forum. Hopefully help will be found here.
04M3 TiAg 69k slick-top 3 pedal
99M3 Cosmos 61k S50B32 euro 6Spd
88M3 AW 43k miles Project FS
WTB: 3.5" Eurosport/Conforti CAI
You could have a bad rubber hose that attaches to the slave cylinder. Did you see if the slave is pushing the clutch release lever towards the front of the car? Did you replace the pivot pin (part 6 in http://www.realoem.com/bmw/enUS/show...diagId=21_0093)?
Bookmarks