Hi
I added a FLA mirror on my E60.
So installed correct mirror. Wired to K_CAN_SL and K_CAN_SH.
Changed the vehicle order to include $5AC in both the LMA and CAS.
Coded CCC_APP trace and changed VA_LONGDISTANCELIGHT to aktive.
When I test with INPA in FLA modul, it reads a value that changes when I put my hand on sensor so I think FA and communication is ok
I can see "high beam assist" in Idrive but when I check to activate, it desaktivates automatically after 1s. What am I missing ? IS something to code in LMA modul ?
Thx
Problems / Fixes
Problem:
A. NCS Expert Error when coding FLA: "COAPI-2020 Ecu does not answer"
B. WINKFP error when coding FLA65: "no answer from ECU"
C. INPA - UIF: FLA is missing from hardware list
Reason: Mirror / FLA wiring wrong. Car does not detect FLA
Fix/Possible causes:
A. Wire joins/solders/bridges not making contact properly. Check/repair.
My $10 connectors didn't work so I did the $0 free option.
Stripped the wires, twisted together & electrical taped. Worked.
B. Wiring order is wrong. DIY video is misleading. Green/Orange are in wrong position. Swap them.
If still not working check your other wires. You have made a mistake.
Problem: Vehicle Order (VO) didn't save. $5AC is missing from list when you check again
Reason: VO is stored in multiple ECU. Or you didn't FA_WRITE
Fix: Update your VO in both CAS + FRM + NFRM
Use EXPERTMODE profile
Also execute the FA_WRITE job to each of above
Problem: above is working but: auto high beam doesn't show in cluster
Reason: These ECUs must be reset: CAS, NFRM, KOMBI, FLA
Fix:
NCS EXPERT (EXPERT PROFILE - to reset to factory settings)
F1+F3=e89 chassis
F6 back
F4 - ECU: Pick the first ECU above
F2 = SG_CODIEREN
F3 = start coding
(repeat for the other ECU's: NFRM, KOMBI, FLA)
Problem: all above working, no high beam assist option in idrive
Fix:
NCS Expert code
CAS: CCC_APPL module
Change: VA_LONGDISTANCELIGHT
from: nicht_aktiv to: aktiv
Now go to idrive - vehicle settings - light - high beam assistant & turn ON.
Problem: How do I use auto high beam?
Press high beam 1 time on stalk. You will see symbol in speedo.
Press one more time to turn highbeam on manually.
Bookmarks