I have replaced my leaking heater control valve and heater core on my 1989 325i. I tested the valve before putting the panels on and it worked fine. Of course once I got it all together it is no longer working. Can anyone tell me what fuse controls the heater valve?
here are all the fuses listed http://shark.armchair.mb.ca/~dave/BMW/e30/
Shogun tricks and tips for the E32 series are HERE!
Remember the heater control valve is normally open. The valve closes when you turn the temp dial to cold. It's possible it's stuck closed, but unlikely. If your problem is no heat, make sure you have properly bled the coolant system.
"Howdy, Folks!"
1986 Delphin 528e - Roof rack equipped lumber hauler.
1989 Zinnoberrot 325iX Sedan - I miss this car. (Deceased)
1998 Avus Blau 328iC - Someone else's project now
2008 Platinum-Beige X3 3.0si - Current project
2012 Alpine White X3 xDrive35i - My new snowmobile.
2020 Estoril Blue 440i xDrive cabrio - This car is a blast to drive.
Thank you for the information
- - - Updated - - -
Thank you. It was a new valve and even though I bled it once it did not work. After bleeding three times it kicked on. Thanks for your advice
Bookmarks