Water Valve Cover ready for production...

[blanz]

I have the first 3D printed water valve cover almost complete and should be ready to ship on Wednesday.
Would the forum member that PM'ed me for one please re-PM me so that I can arrange shipping and payment.
I will be producing these on-demand.
Refer to the post below.
https://www.bimmerforums.com/forum/s...rnate-solution

Thanks, Bill.

[blanz]

I have the first 3D printed water valve cover almost complete and should be ready to ship on Wednesday.
Would the forum member that PM'ed me for one please re-PM me so that I can arrange shipping and payment.
I will be producing these on-demand.
Refer to the post below.
https://www.bimmerforums.com/forum/s...rnate-solution

Thanks, Bill.

First production piece was shipped Friday.
I will complete a second one this week and have available for immediate shipment.
Thanks. Bill

[mbarrett635]

I just received mine from Bill -- very nice. See pictures below. It's definitely sturdier than the original, fits perfectly, and unlike the original -- YOU CAN TAKE IT OFF WITHOUT BREAKING IT! Woo-hoo. I bought this to replace a broken one, but I'll probably get another for my other 8, even though that one's not broken.

I might do a little more finishing on the outer surface (what else have I got to do, since it's put away for the winter), but I'm very happy with this.

Cover 02.jpg

Cover 01.jpg

Cover 03.jpg

[blanz]

I just received mine from Bill -- very nice. See pictures below. It's definitely sturdier than the original, fits perfectly, and unlike the original -- YOU CAN TAKE IT OFF WITHOUT BREAKING IT! Woo-hoo. I bought this to replace a broken one, but I'll probably get another for my other 8, even though that one's not broken.

I might do a little more finishing on the outer surface (what else have I got to do, since it's put away for the winter), but I'm very happy with this.

Cover 02.jpg

Cover 01.jpg

Cover 03.jpg

Thanks Mike. Glad it worked well for you.
I have improved the surface finish on the second unit as I knew it could use a bit more finer finish.
Second one is completed today and bagged for the next order.
Bill