My build is on the way
S50 intake
Schrick valves & spring
Sunbelt stage 3 made for hydro lifters
Knife edge crank
10;5;1 JE piston, Will run 94 fuel
Cometic head gasket
Pauter rod
Red top Bosch injector
PS delete
Vanos rebuild (seals and bearing)
Lite pulley (alternator and water pump)
Jb flywheel
All new internal
What would be the limit rpm for the hydro lifters
Should I sell the cam and buy solid lifters cams?
I have a set of solid lifters ready to use
Will run Adaptronic ECU
Thank
Last edited by Marc124444; 12-01-2018 at 06:05 PM.
I think the RPM limit with hydraulic lifters is ~ 7000, not a lot higher with solid lifters.
Sounds like you are looking to go S54.
Sent from my iPhone using Tapatalk
Bookmarks