I replaced the window regulator on my e46 coupe. I thought I put the glass back where it was before, but there is a very slight gap at the top where the window doesn't go up all the way. Are there any tips for adjusting? Or do I have to reposition the window withing the regulator?
Thanks
Have you reset the window yet?
Start the car. Roll the window DOWN and hold the button in the down position for 12 seconds. Roll the window UP and hold the button in the up position for 12 seconds. This resets the window.
Last edited by All2kool; 11-27-2018 at 04:50 PM.
It does. But not as much as it used to. When I lower the window all the way, a very small portion still can be seen above the door. And when i take the window all the way up, it doesn't quite seal. If I continue to pull up on the lever to raise the window, I can hear the motor try to raise it further, but it doesn't move.
It's almost like the brackets on the regulator that hold the glass are moving. Or stop moving before reaching the fully up or down position. If that makes any sense at all.
Bookmarks