Hey people. Anyone using Mikes BMW TOOLS.
I purchased this from ebay 1 week ago. Finally go the drivers installed and using Kline interface witha Round ended adapter for the can connection under the bonnet. Well i hope that what ~I am using. TBH i have no clue. USB > OBD > a big round black thing. I ued many times before 7 years ago and now needing to use it again.
I originally lost all software for the BMW. Hence purchased Mikes tools. Upon install. I am trying to use the INPA. E39 exists but the engine model M51 does not appear. Try E36 and E34 and yes it appears in their to use.
Well, selecting the model that i need. M51 I am now geting an error- IFH-0006 . command not accepted. WTH is going on. I am no programmer and never had this issue 7 years ago.
please assist.
not sure if I can POST here a link to a MEGA download page. However if not you can delete this post. This is another place where i downloaded mikes software. This one i think is better than the one i bought. Did not give me the command problem IFH0006... Do not know if the package was corrupted but will try this out tomorrow. https://mega.nz/#!wdIDSSTK!8TPthuUzA...IcUBVKgNzL_yxU
Bookmarks