u owe my mule an apology
Hey guys, I made some tools for installing the tappet trays in an M50 and since I have had very good success selling cam timing blocks I decided to make a bunch of these and see if anyone else is interested. They are 3d printed plastic and have a small magnet in them to hold up each lifter. Keeps the lifters from dumping all over when you remove or install the lifter trays.
Will fit an M42, M50, S50us, M52, S52, and M54
I am listing them on ebay but if you PM me directly I will sell them for $5 off and free shipping worldwide
$30 for a set of 6
$40 for a set of 12
https://www.ebay.com/itm/183878691374
https://www.ebay.com/itm/183878699467
If you know a group that would want these please share
86 325es, 2.8L m50, S476sxe, ProEFI 128 ecu, e85, solid rear axle, TH400 trans, 28x10.5w slicks, zip ties, popsicle sticks, tape
best time 9.06 @ 151.8 mph, best 60 foot 1.30
Member
This is awesome! Always contributing. I’ll grab 12 off your eBay page.
u owe my mule an apology
Cool, thanks!Originally Posted by 1SLWM3
86 325es, 2.8L m50, S476sxe, ProEFI 128 ecu, e85, solid rear axle, TH400 trans, 28x10.5w slicks, zip ties, popsicle sticks, tape
best time 9.06 @ 151.8 mph, best 60 foot 1.30
Posting Permissions
Reply With Quote
Bookmarks