Hello everyone,
I successfully built the
almost free ADS interface and installed INPA V5.0.2 on a Windows XP with a real serial port. My car has a DME 3.3.1 and INPA couldn't connect to it since it was expecting DM331K20 but the detected control unit is DME331. I searched a bit and found a
DME331.prg file; I copied it to EDIABAS\ECU folder but still, INPA expects to see DM331K20. At least I'm able to read fault codes with Tool32, so I think I went through the installation correctly. That was very useful but I really need to see live sensor information from the engine in order to diagnose improper engine operation. I've tried installing and uninstalling the whole thing but no success.
I kindly ask for your input on this issue.
Thanks!
Bookmarks