Sob story here:
https://www.bimmerforums.com/forum/s...er-replacement
Short version is I have an INPA laptop I use for my E36 and E38. Those cars I use the OBDII cable with the round underhood adapter and it works great, but I can’t ready any codes on the X3. Will need to double check the error message, but IFH-009 or something rings a bell.
Any help is welcome.
You need a D-CAN cable to read the engine module on the X3. And probably need to solder pins 7 and 8 to read any other module.
Is the cable in D-CAN mode?
Try using dcan tools to initiate the dcan cable setting after plugging the cable in...
Sent from my SM-N960U using Tapatalk
Sadly running the dcan tool did not work. Maybe it's the cable. Thanks for the link and for sending the dcan software Purp.
Bookmarks