Results 1 to 11 of 11

Thread: 2014 F30 Halo Rings

  1. #1
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive

    2014 F30 Halo Rings

    newbie question:

    I have two non working angel eyes on the drivers side. Trying to figure out if the rings themselves are the lights or is there a bulb that shines light into the rings.
    I'm pretty sure i have the Bi-xenon lights. They are a bright crystal white and the car came with exec/premium/sport package. Is bi-xenon the same as LED lightning?
    If it is the rings that need to be changed i assume getting into the headlamp assembly would be no easy task. ( any DYI videos out there)
    If it is a bulb then there must be one for each ring and why would both go at the same time?
    Is there one ballast (or power module) for both rings or is it a case if one goes the other goes too?
    Or might it be a total software issue and i need the proper reader to get them on again.
    On a side note i did notice condensation building up in that one headlight assembly.

    Any info/links would be greatly appreciated.

    thanks

  2. #2
    MauiM3Mania's Avatar
    MauiM3Mania is offline Observer/Master Skeptic Moderator
    Join Date
    Jan 2002
    Location
    Central Pacific
    Posts
    10,809
    My Cars
    88M3 99M3 04M3 ITBx16
    Moved from the General BMW Discussion sub-forum.
    04M3 TiAg 69k slick-top 3 pedal
    99M3 Cosmos 61k S50B32 euro 6Spd

    88M3 AW 43k miles Project FS


    WTB: 3.5" Eurosport/Conforti CAI

  3. #3
    Join Date
    Jan 2016
    Location
    Ca
    Posts
    6,981
    My Cars
    2001 525it
    Only Bulb per rings the light travels thru clear plastic tubes

  4. #4
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    Quote Originally Posted by jclausen View Post
    Only Bulb per rings the light travels thru clear plastic tubes

    Is that one bulb per ring then?

    i assume that would be accessible by removing the wheel well cowling?

    thanks

  5. #5
    Join Date
    Jul 2004
    Location
    Houston, TX
    Posts
    12,461
    My Cars
    36 Cylinders
    It is not a bulb, it's an LED module that plugs into the headlight. You really should have the car scanned for errors, as it would tell you if there is a short, or a fault with something else than the module.

    You do not have the LED headlights (facelift only), you likely have the bi-xenon.

    Here is a breakdown of parts. You may be able to access it without taking too much apart, or not. I wouldn't depend on youtube, as they are usually wrong.

    Factory instruction manuals uploaded by someone. Dig in:
    https://www.newtis.info/tisv2/a/en/


    Part #3, one per headlight:

    http://www.realoem.com/bmw/enUS/show...diagId=63_1356
    Last edited by 328 Power 04; 11-05-2018 at 11:52 AM.
    -Abel

    - E36 328is ~210-220whp: Lots of Mods.
    - 2000 Z3: Many Mods.
    - 2003 VW Jetta TDI Manual 47-50mpg
    - 1999 S52 Estoril M Coupe
    - 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
    - 2019 M2 Competition, self-tuned, 504whp
    - 2016 Mini Cooper S

  6. #6
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    Thanks for that info. Very helpful.
    These are my lights. Can u tell me if they are Bi-xenon or LED or both.
    Also have an issue with condensation in that one headlamp. May have attributed to the problem of a short.
    My understanding is if there is a detected short then the FVM (im not sure what that is) will shut off power to that light module. Correct me if i'm wrong.
    Is there any way to test for voltage in/out with a multimeter on the lights or is the scanner necessary?
    I was just about to order the Foxwell NT520 OBD2 , i'm hoping that will help me diagnose and correct.
    in the meanwhile i was going to try to access that lamp from the wheel well and look for obvious faults
    trying to stay away from the dealer

    IMG_20181105_075316762_HDR.jpg

    thanks again.


    IMG_20181105_075415797.jpg

    0.jpg

  7. #7
    Join Date
    Jul 2004
    Location
    Houston, TX
    Posts
    12,461
    My Cars
    36 Cylinders
    Only the 2016-ish + facelift models got the LED headlights.
    You have bi-xenon.
    But your halo rings (angel eyes) are LED powered.
    You may not be able to get anything useful out of a test with a multimeter if the control module determined that there is too much of a short to keep it alive, usually in an attempt to save other components from damage.

    Do not try to apply +12V to anything.

    LED module for rings may simply be dead.
    -Abel

    - E36 328is ~210-220whp: Lots of Mods.
    - 2000 Z3: Many Mods.
    - 2003 VW Jetta TDI Manual 47-50mpg
    - 1999 S52 Estoril M Coupe
    - 2014 328d Wagon, self-tuned, 270hp/430ft-lbs
    - 2019 M2 Competition, self-tuned, 504whp
    - 2016 Mini Cooper S

  8. #8
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    Who thought lights could be so complex? Took the wheel well liner out to have a look. Dropped the LED modules out , blew off a bunch of scale that must have accumulated from moisture being in that lamp. Took out the orange parking bulb and blew compressed air in there to try to get rid of the condensation. Also that small circuit board.
    Oddly enough when I put everything back together the halos worked for about a minute then went out again.
    I guess I'll wait for the scanner to see if I can reset them back on.
    Not sure why I'm getting condensation in only the one headlamp and not the other. Even without driving the car.

  9. #9
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    Just getting around to this issue again.
    I swapped the headlight module (#5) from the right side (working) to the left side( not working)
    It made no difference, iî so I can assume the headlight module is good.
    I was going to do the same with the LED modules (#3) but couldn't
    Figure out how to disconnect the electrical connection without
    breaking it. It's pretty small and delicate.
    Any ideas how it's done?
    Thanks

  10. #10
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    Does anyone know how to test these LED modules to see if they are good or not?

    there are three small brass pins as well as the two side contacts that are attached to a terminal, that broke of while i was trying to disconnect it.

    both LED are out want to try to isolate the problem before buying new ones.
    IMG_20190126_121640587.jpg
    Thanks

  11. #11
    Join Date
    Nov 2017
    Location
    calgary, canada
    Posts
    36
    My Cars
    2014 328i xdrive
    for anybody interested, i ended taking a chance a buying two new LED modules from China, ($55 each) without knowing what the problem really was, and putting them in.

    Low and behold they work. Though it would still be cheaper than going to the shop , having a scan, and being told maybe thats the problem

    Pulling out the old ones you can see all the scale and crud deposit from condensation occurring in the headlamps (a common problems with these models).

    Even if they last only a few years , i wont mind. Ill also dry out the headlamps from time to time.

    Still a mystery as to why both of them went out at the same time. I guess these must be wired in series , so to speak.20190322_154406-1152x864.jpg

Similar Threads

  1. F30 2014 F30. Is it supercharged?
    By dprosus in forum 2012-2019 (F30, F32, F33, F34, F36)
    Replies: 10
    Last Post: 08-05-2016, 12:02 AM
  2. WTB: Halo rings for E36 M3
    By TheStigE36 in forum BMW Parts Wanted
    Replies: 1
    Last Post: 02-27-2006, 03:28 PM
  3. Halo Rings
    By bimmer540wsubs in forum 1988 - 1996 (E34)
    Replies: 5
    Last Post: 01-03-2005, 09:40 PM
  4. 1 Halo Ring Out?
    By MLOVE in forum 1992 - 1999 M3 (E36)
    Replies: 8
    Last Post: 04-14-2004, 05:11 PM
  5. Halo Rings Dim on 1 Side
    By MLOVE in forum 1992 - 1999 M3 (E36)
    Replies: 19
    Last Post: 03-10-2004, 05:53 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •