ok so I am trying to use ncs to do a lil coding on my car, I have the ncs profile downloaded but am still a bit confused on how I actually use it, I'm confused on if I can use this profile for both reading and coding the car or if I use one profile for reading and one for coding? this is the idea I have so far, I open ncs and load ncs dummy profile then select f1 then select chasis, them make sure that the job says reading not coding and then process ecu, I then open ncs dummy and load the trc file that was just created, make whatever changes to things I plan on doing then export the file back to ncs expert, then follow same steps on make sure that this time it says coding under job rather than just reading, how close am I to how it works? lol