Hi,
Is it possible to replace protective moulding at the bottom of the doors with a used set or would these get deformed and/or damaged if you even try to pull them from a parts car?
My driver side door could use a nice clean one, but not sure I want to pay dealer cost for it.
#51131934177
http://www.realoem.com/bmw/enUS/show...diagId=51_0769
e30 84 340i m6x powered.
e34 89 535i 5speed - current DD
e24 89 635csi - maybe a DD?
e34 93 525i (m50tu) - gone
e39 540i 6spd m-sport - gone
e53 x5 4.4l - gone
e30 89 325i (m20) - gone
You can pull them on and off. I've done so twice since I had a missing clip and they clip back on easily.
https://www.youtube.com/watch?v=iROfARX_Y1c
The part number you gave is for the one about one-third of the way up the door, the bump protector as I call it.
If you mean the rubber strip at the bottom of the door, yes, you can reuse them. They can curl up when removed if they have been on the car a while, if so just hit them with a heat gun before installation. Watch for latent rust underneath.
If you want, I have a full set of those, all 4 doors almost new (put them on and realised I needed Mtech ones) for $80 shipped.
Parts 51211944419, 51211944420 and 2x 51211944421
Last edited by tantumaude; 10-14-2018 at 11:46 PM.
Good catch ! I was looking at the wrong ones on realoem, I need the one that’s on the bottom of the door and looks like they are cheap new ! Don’t want to deal with having to straighten a used one so I’ll just get one from a dealer this time . Thanks !
Bookmarks