I am missing my front passenger and rear driver side sill plates. Assuming they would fit, from a sedan, I scoured some from the junkyard today; only to find that they dont fit. The front passenger side may fit, but I found it to be a bit different than the ones i already have. I did manage to find another msport steering wheel, in better shape than the one i found last week. 😁
Yep, no differences between wagon and sedan.
Set the controls for the heart of the sun
The alignment pins slide up from their correct positions when you remove/disturb them. Just make sure all your pins are in place, the holes have the little plastic wedges in place and reinstall. Simple
Yes, some of the trim will need to be "massaged" into place. Make sure you treat them with some Armor All - 303 or whatever product you like before installing them. Then wipe off your finger prints and enjoy your shiny protection parts.
Current Garage Highlights
2003 525iT TiSilver
2002 M5 TiSilver
1998 528i KASCHMIRBEIGE METALLIC (301) (Goldie)
Former Garage Highlights
2005 X5 4.8is
2004 325iTs (2x)
1973 Pantera L
1971 Dodge Dart Swinger "Lite Package"
1970 Dodge Challenger T/A 340 Six Pack Alpine White
1970 Dodge Challenger T/A 340 Six Pack GoManGo Green
1969 Road Runner 383
1968 Barracuda Formula S 340 Sea Foam Green
Turns out, there were only two holes that I could put the pins in. Could not use the third pin, near the rear, because there was no hole.
Wagon727 In the front or rear door locations?
- - - Updated - - -
Snotty, Can you post a photo on the bottom side of the trim plates?
Current Garage Highlights
2003 525iT TiSilver
2002 M5 TiSilver
1998 528i KASCHMIRBEIGE METALLIC (301) (Goldie)
Former Garage Highlights
2005 X5 4.8is
2004 325iTs (2x)
1973 Pantera L
1971 Dodge Dart Swinger "Lite Package"
1970 Dodge Challenger T/A 340 Six Pack Alpine White
1970 Dodge Challenger T/A 340 Six Pack GoManGo Green
1969 Road Runner 383
1968 Barracuda Formula S 340 Sea Foam Green
Rear.... There was a hole for the pin that sticks out of the plate, that just presses in. And there were three "adjustable" pins. But, I only had holes for the two most forward adjustable pins ( looks like they were drilled). But no hole for the rear most pin. I did install the plate, but its loose at the back side. Maybe I'll just rig it and use double sided tape.
When in doubt just use super glue. It not like the fifth/sixth and final owner is going to worry about door scuff panels....
Current Garage Highlights
2003 525iT TiSilver
2002 M5 TiSilver
1998 528i KASCHMIRBEIGE METALLIC (301) (Goldie)
Former Garage Highlights
2005 X5 4.8is
2004 325iTs (2x)
1973 Pantera L
1971 Dodge Dart Swinger "Lite Package"
1970 Dodge Challenger T/A 340 Six Pack Alpine White
1970 Dodge Challenger T/A 340 Six Pack GoManGo Green
1969 Road Runner 383
1968 Barracuda Formula S 340 Sea Foam Green
Bookmarks