Pulled the engine out and did a ton of work and now I'm putting it all back together. I have a diagram for the coolant hoses but it's hard to tell which hoses go to the heater core.
Does someone have a pic or point out which hoses go to the heater core?
Thanks
Last edited by gilber33; 09-01-2018 at 10:12 PM.
See if this helps
https://www.bimmerforums.com/forum/s...g#post29850779
Last edited by RomeoMike; 09-02-2018 at 05:43 PM.
On Christ the solid Rock I stand, all other ground is sinking sand. (Edward Mote 1797-1874)
Thank you. I also found this one: https://www.r3vlimited.com/board/sho...d.php?t=380098
Now that that's figured out, how about where the two hoses on the TB go? I know ome is from the thermostat.
The TB hose goes from thermostat to TB to a nipple on the side of the block above the starter.
"Howdy, Folks!"
1986 Delphin 528e - Roof rack equipped lumber hauler.
1989 Zinnoberrot 325iX Sedan - I miss this car. (Deceased)
1998 Avus Blau 328iC - Someone else's project now
2008 Platinum-Beige X3 3.0si - Current project
2012 Alpine White X3 xDrive35i - My new snowmobile.
2020 Estoril Blue 440i xDrive cabrio - This car is a blast to drive.
Bookmarks