Installing a rebuilt M10 motor in my 1982 320i and would like to install a new clutch as well. Is there any preference in name brand, so many to choose from and from what I have read on this forum it seems that SACHS is the preferred choice. There are some I have never heard of such as LUK, FX stage 1, Platinum Driveline, Rhino Pac. Any suggestions would be greatly appreciated. Thank's in advance.
running a LUK for past 5 years, german made, no problems. i remember paying $89 shipped for 3 piece kit online. good luk! sorry........
Get in touch with Ireland Engineering (socal) and get a Sachs kit from them. Inexpensive and great quality. The kit comes with a T/O bearing as well.
Luk Here too, Luk 03-002 Clutch Kit
$_32.JPG
Randy
Thank's guys for all your input. found the LUK #03-002 brand at Rock Auto for $125.88 shipped to my house, Not bad that means I can get the header from Ireland Engineering.
came across this question while going through my engine rebuild. I was told to lighten my flywheel that it would make a big difference but I have a stock 1.8 4cyl engine nothing fancy. What do you think legion?
There are plus's and minuses to weigh out. I'm a centurion
Here is an article on it.
http://www.infinitegarage.com/light-...pros-and-cons/
Randy
Last edited by 320iAman; 07-27-2018 at 12:28 AM.
Thank's for the article Randy, I have made my mind up and will opt to stay with the stock flywheel.
Bookmarks